Subscribe | Some of the key features of this controller are:
Microprocessor controlled -- This is very important for both stability and functionality.
Settings are user changeable! By simply turning a simple potentiometer with a small screwdriver, you can quickly adjust the trip point.
Super High amp rating - 440 Amps -- 10,000 watts. -- .
Works directly with 12, 24 or 48 volt systems. -- The relay contacts can handle open collector voltages of up to 120 volts. Connect multiple turbines and solar panels up to 440 amps worth at the same time! Max solar amperage in disconnect mode is 100 amps. Max solar amperage in divert mode is 440 amps. This is a huge hybrid wind and solar charge controller.
High Contrast LED battery voltage. - Several controllers do not tell you what's going on - This one does!
High Contrast LED turbine amperage meter.
Meters can be shut using the on/off switch.
Two factory installed, fully wired D/C breakers and disconnects.
Entire unit is wired and ready to go for b | |
| Read more |  | |
Tag → Charge
HVA All in One Charge Controller for Wind Turbine Generators & Solar Panels
Ten-high 100W 200W 300W DC input 12V Portable Wind charge controller for DC Output Wind Turbine Generator
 | Product performance:
1.This controller can control wind turbines for automatic charging battery. Under the condition of the battery is full of, through internal automatic control circuit to make the brakes, when the battery voltage drops to the recovery voltage, wind turbine back for battery charging, so as to protect the wind turbine and battery.
2.Comprehensive waterproof protection. This controller USES the seal completely waterproof design, all of them, and don't have to worry about air humidity, salinity, such as ground water use environment, protection grade reaches the IP67 above, even in water can normal use for a long time, improve the reliability greatly.
Mode of connection:
1.Respectively connected to the battery "+" and "-" to the battery positive and negative terminal of the controller.
2.Respectively connect wind generators rectifier output anode and cathode side to the Wind Turbine input anode and cathode terminal of the controller.
Note:
1.Confirm the rati | |
| Read more | | |